Is it difficult to install PC boards? Mastering the method won't be difficult at all!
2023.01.29
I. When bending the polycarbonate sheets, it should be done along the force direction, and never be bent laterally. The bending radius should be 175 times the thickness of the sheet for a hollow two-layer sheet, 185 times for a three-layer sheet, and 200 times for a four-layer sheet. The bending radius for solid reinforced polycarbonate sheets should also be 175 times the thickness. The bending part of the sheet must not be fixed with screws.
II. When installing hollow sheets and solid reinforced polycarbonate sheets, at the joint of the sheets, a thermal expansion gap must be reserved according to the size of the sheet. The thermal expansion coefficient is 0.065mm/m℃. Do not use self-drilling screws, pull rivets, etc. to fix directly through the sheet. If it must pass through, a hole with a diameter larger than 100% of the diameter of the self-drilling screw or pull rivet must be drilled on the sheet, and then the self-drilling screw or pull rivet must pass through the center of the enlarged hole to ensure that the sheet can freely expand in any direction.
III. The steel structure framework must be installed firmly and balanced to avoid damage to the polycarbonate sheet due to the framework.
IV. The steel structure framework materials must be consistent with the structural area to facilitate construction.
V. The aluminum alloy strips must match the thickness and area of the purchased polycarbonate sheets to better protect the sheet and extend its service life.
VI. The sealing glue in contact with the polycarbonate sheet must be neutral silicone copper glue. Do not use alkaline, acidic, or sealed glue with unknown chemical composition and solvents. Avoid direct contact between the polycarbonate sheet and chemical solvents, solutions, and volatile gases. If using diluted paint to spray the support frame of the polycarbonate sheet, it must be dried before installing the polycarbonate sheet, and do not use diluted paint to patch the steel framework that has already installed the polycarbonate sheet.
VII. When installing and fixing the polycarbonate sheet, it is necessary to use the company's dedicated anti-rain and up-down complete set fasteners or the company's provided dedicated flat plate strips. If using other company's flat rubber strips, it is necessary to ensure that the material of the rubber strip is EPDM rubber or butadiene rubber. Do not use polyvinyl chloride (PVC), natural rubber, etc. which contain substances harmful to the polycarbonate sheet.
VIII. When installing the polycarbonate sheet, the sheet with the UV co-extruded anti-ultraviolet layer and the text protection film on the outside must be oriented towards the outside. Do not install it in reverse. Immediately remove the protection film after installation to avoid the adhesion of the protection film and the polycarbonate sheet after being exposed to the sun.
IX. Before installing the polycarbonate sheet, remove the protection film within a range of about 30mm from the edge. Do not press the protection film under the profile. Use the method of cutting the protection film with a knife. No scratches are allowed on any part of the polycarbonate sheet.
X. Seal the cross-section of the polycarbonate sheet with aluminum foil tape or waterproof breathable tape to prevent water vapor, dust, and small insects from entering the cavity, affecting the transparency and aesthetics of the polycarbonate sheet.